VA Hospital Operating Room Boom Electrical Upgrade in Aurora, Colorado

What is an operating room boom electrical transfer? An operating room boom electrical transfer is the controlled disconnection of a ceiling mounted equipment boom from building power, the removal or replacement of the boom hardware, and the reconnection and verification of that power so the room can return to clinical service. Equipment booms carry electrical receptacles, data, and medical gas outlets to the surgical field on articulating arms, so the electrical work sits inside one of the most demanding environments in the hospital. The Electricians performs this work for federal and private health systems throughout the Denver metro.

At the Rocky Mountain Regional VA Medical Center in Aurora, the Level 3 buildout upgraded booms in 17 operating and procedural rooms. The Electricians provided the labor, skills, and tools to disconnect each existing boom, support the boom replacement, and reconnect and restore the electrical systems so a safe and efficient transfer was made in every room.

The scope covered seven operating rooms, four GI procedure suites, three minor procedure rooms, two ERCP rooms, and a control room. Each room was restored to the standards of the boom manufacturer, the VA specification, and federal, state, and local electrical code before it returned to service.

Across the Level 3 buildout at the Rocky Mountain Regional VA Medical Center, the electrical scope followed each boom from disconnect through reconnection and turnover.

The table below summarizes the rooms and systems The Electricians handled during the Level 3 boom upgrade.

Hospitals are not ordinary commercial buildings from an electrical standpoint, and a federal medical center adds another layer. NEC Article 517 and NFPA 99, the Health Care Facilities Code, govern how patient care areas are wired, how receptacles and grounding are handled near the patient, and which loads must stay energized when normal power is lost.

Operating rooms sit at the top of that hierarchy. Booms deliver power directly to the surgical field, so the circuits that feed them are treated as critical, and the way they are grounded, protected, and restored is not left to general commercial habits.

On a VA project, the Department of Veterans Affairs publishes its own electrical specification on top of the national codes. The Electricians worked to the VA specification, the boom manufacturer requirements, and federal, state, and local code on every one of the 17 rooms.

The Level 3 operating and procedural rooms at the Rocky Mountain Regional VA Medical Center stayed in use while the boom upgrade moved through the floor. Surgeries and procedures continued in adjacent rooms, so nothing about the work could introduce an unplanned interruption.

Our team verified what each circuit served before it was touched, coordinated shutdowns with facility engineering, and sequenced the 17 rooms so the department kept operating. Access, containment, and cleanup followed the requirements the VA sets for construction in occupied clinical areas.

The result was a room by room transfer delivered inside a working surgical department, with each room restored and turned back to the facility before the next one came offline.

What is a surgical equipment boom? A surgical equipment boom is a ceiling mounted, articulating arm system that brings electrical receptacles, data connections, medical gas outlets, lighting, and equipment shelves to the surgical or procedural field. Booms keep cords and hoses off the floor and let staff position monitors, anesthesia equipment, and surgical devices where they are needed. The Electricians handles the electrical side of boom installation and replacement for hospitals throughout the Denver metro.

Because a boom feeds equipment that is in use during a procedure, its electrical connections have to be correct in every detail. Receptacle circuits, grounding, and any equipment specific connections must match the manufacturer drawings and the hospital specification before the room is released.

At the VA medical center, each of the 17 rooms received that level of attention through disconnect, replacement support, and reconnection.

Boom manufacturers publish detailed electrical requirements, and the VA publishes its own specification for how electrical systems in its facilities are built and documented. Neither can be treated as optional on a federal healthcare project.

The Electricians coordinated the reconnection of each boom against the manufacturer requirements and the VA specification, then completed the work to federal, state, and local code. That coordination during the transfer is what avoids rework after the boom vendor and the facility inspect the room.

Restoring 17 rooms to those standards on a working surgical floor is the kind of scope our commercial division is built for.

The Electricians partners with federal agencies, health systems, general contractors, construction managers, developers, and facility operators throughout Colorado. From operating room electrical and hospital renovations to medical office build outs, power distribution, and complete commercial electrical systems, our commercial division works inside facilities that cannot afford downtime.

The Electricians is a family owned, licensed electrical contractor based in Centennial, Colorado. We are not owned by a private equity group. When you hire our commercial division, you work directly with the people who run the company, and decisions about your project get made here in Colorado rather than at a corporate office in another state.

Common questions from federal facilities, health systems, general contractors, and facility managers planning operating room or hospital electrical work in Colorado.