The Electricians · Plumbing Division

Denver Faucet Repair, Fixture Replacement, And Toilet Installation

Dripping faucets, running toilets, leaking shower valves, dead garbage disposals, and fixture replacements across kitchens and bathrooms. We repair and install faucets, sinks, toilets, tub and shower valves, disposals, and dishwashers, with a written price before anyone starts.

Kitchen And BathroomRepair Or ReplaceUpfront Written Pricing
Book A Fixture Visit

Tell Us What Is Leaking

Kitchen, bathroom, repair or replacement
No Cost Consultation
Licensed & Insured
★★★★★
4.9 · 350+ Reviews · BBB A+
⏱ Takes 30 seconds - we'll reach out to confirm your appointment.
Service Address (optional - we'll confirm on the call)
Pick a Date
Plumbing License
CO Lic. #PC.0005786
Electrical License
CO Lic. #EC.0101962
Insurance
2M GL · 5M Umbrella
Family Owned
Since 2020
Small Jobs, Real Consequences

A Dripping Faucet Is Rarely Just A Faucet

Most fixture calls we take are the second or third attempt at the same problem. Usually because the first two fixed the symptom.

What counts as a plumbing fixture? A fixture is any point where water enters or leaves the plumbing system for use: faucets, sinks, toilets, tubs, showers, and the appliances tied into them such as garbage disposals, dishwashers, and instant hot water dispensers. Fixture work is the most common plumbing service in any home, and the one most often done twice.

A faucet that drips again three months after a cartridge replacement usually does not have a faucet problem. It has a water pressure problem, or hard water chewing through seals, and swapping parts without checking either one guarantees a repeat visit. That is the difference between replacing a component and diagnosing a system.

We check static pressure and look at the supply lines on every fixture call, whether you asked us to or not. It takes a few minutes and it is the reason our fixture repairs tend to stay repaired.

Kitchen

Kitchen Plumbing Fixtures

Kitchen faucet repair and replacement
Kitchen sink installation
Garbage disposal repair and replacement
Dishwasher hookup and replacement
Instant hot water dispenser
Pot filler installation
Refrigerator water line
Sink drain and P-trap repair
Air gap and drain line clearing
Water filtration at the sink
Bathroom

Bathroom Plumbing Fixtures

Bathroom faucet repair and replacement
Toilet repair and replacement
Running and leaking toilet repair
Toilet flange and wax ring replacement
Tub and shower valve replacement
Shower head and diverter repair
Sink, vanity, and pedestal basin install
Tub spout and overflow repair
Bidet and bidet seat hookup
Fixture work for bathroom remodels
Why Fixtures Fail Here

Three Things That Kill Fixtures In Denver Homes

The first one is the reason most repeat repairs happen, and almost nobody checks it.

01

Water Pressure Above Code Limit

Plumbing code caps static water pressure inside a home at 80 psi. Denver sits on rolling terrain, and elevation differences across the distribution system mean plenty of homes see pressure well above that, particularly in lower lying neighborhoods. High pressure destroys faucet cartridges, forces toilet fill valves to weep, shortens the life of every seal in the house, and voids most fixture warranties. It is also the single most common reason a repaired faucet starts dripping again. The fix is a pressure reducing valve at the service entrance, not another cartridge. We measure static pressure with a gauge on every fixture call so you find out before you pay for the same repair twice.

02

Hard Water On Cartridges And Aerators

Denver water carries enough mineral content to scale up the small passages inside a fixture. Aerators clog and flow drops. Cartridge seals grind against mineral deposits until they leak. Shower diverters stiffen and stop holding. A lot of fixtures written off as worn out are actually just scaled, and cleaning or rebuilding them costs a fraction of replacement. We will tell you which of the two you are looking at.

03

Supply Lines Nobody Thinks About

The flexible line feeding your faucet or toilet is the most likely thing in your house to cause catastrophic water damage, and supply line failures are among the most common residential water claims. The failure point is almost always a plastic compression nut that has gone brittle with age. Braided stainless lines with metal nuts cost very little more and fail far less. We replace them as part of any fixture work rather than reconnecting a line that is already ten years old.

The Honest Answer

Repair The Fixture Or Replace It?

We do not have a policy of always replacing. Here is how the decision actually goes on site.

Factor Repair Usually Makes Sense Replacement Usually Makes Sense
Faucet A known brand with parts still available, solid body, finish you still like. A cartridge and seals fix it. Builder grade or discontinued, corroded body, or a third repair on the same unit.
Toilet Fill valve, flapper, flush valve, or supply line. All inexpensive parts on a sound bowl and tank. Cracked tank or bowl, a rocking bowl on a failed flange, or an old high volume flush you want to cut.
Tub or shower valve Cartridge or trim replacement where the valve body behind the wall is in good condition. Failed valve body, no available parts, or a two handle valve being converted to a single pressure balancing one.
Garbage disposal Jammed flywheel, tripped overload, or a leaking sink flange that can be resealed. Leaking from the body shell, seized motor, or a unit undersized for the household.
Sink drain Slip joint, P-trap, or tailpiece replacement. Straightforward and cheap. Corroded metal drain assembly throughout, or a rough in being moved for a remodel.
Any of them The rest of the system checks out and pressure is within code. Pressure is over code limit. Replace the fixture and it will fail the same way. Fix the pressure first.
Make It Last

Garbage Disposal Care: What Helps And What Ruins Them

Most disposal calls are avoidable. Here is what actually matters, and one item on the right surprises almost everybody.

Do This

Run a moderate flow of cold water the whole time you grind.
Let the water and the disposal keep running for a few seconds after grinding stops, so the debris clears the trap.
Grind a small piece of citrus peel occasionally to freshen the chamber.
Feed waste in gradually rather than filling the chamber and switching on.
Use a disposal cleaner or degreaser periodically.
For odors, drop in ice cubes and lemon peel, run it 30 seconds, then flush with cold water for 20.

Never Do This

Do not use hot water while grinding. It melts fats so they re-congeal further down the drain. Hot water between grinding cycles is fine.
Do not shut off the disposal or the water before grinding is finished.
Do not grind fibrous waste such as corn husks, artichokes, onion skins, or celery. The strands wrap the flywheel.
Do not overload the chamber. It stalls the motor and trips the overload.
Do not pour liquid grease down the drain. Wipe congealed grease into the trash first.
Do not reach into the chamber without cutting power at the switch and the breaker.

If the air gap on top of your sink spits water, something is restricting the drain line. Check that the line from the air gap is not kinked and that nothing is partially blocking it where it ties into the drain.

Where We Are Different

Half The Fixtures Under Your Sink Are Electrical Too

Disposals, dishwashers, and hot water dispensers all need circuits, switches, and GFCI protection. We hold both licenses, so none of that becomes a second appointment.

A garbage disposal needs a properly sized circuit and a switch located where you can actually reach it in a hurry. A dishwasher needs its own dedicated circuit. An instant hot water dispenser needs a receptacle under the cabinet that often is not there yet. Current code also requires GFCI protection for these receptacles in a dwelling kitchen, and older kitchens frequently do not have it.

That is where a straightforward fixture swap turns into two contractors and two trip charges for most plumbing companies. We hold a plumbing contractor registration and an electrical contractor license, so the disposal, the circuit, the switch, and the GFCI are all one visit under one written price.

It also means we notice the things a plumber alone would leave. A disposal wired into a shared circuit that trips whenever the microwave runs is not a plumbing fault, but it is still the reason your disposal keeps cutting out.

Customer Supplied Fixtures
Bought Your Own Faucet? We Will Install It
Plenty of homeowners pick their own fixtures, and that is completely fine. Bring the faucet, the toilet, or the disposal and we will install it. We will tell you honestly before we start if the fixture is not going to fit the rough in or the countertop, so you have time to exchange it rather than finding out with the water off.
Questions

Frequently Asked Questions About Denver Fixtures

It depends on the faucet. A known brand with parts still available, a solid body, and a finish you still like is usually worth a cartridge and seal rebuild. Builder grade or discontinued models, corroded bodies, and any faucet on its third repair are better replaced. Our plumber tells you which one you have before quoting either path.
Most often because the water pressure in the house is above the code limit of 80 psi. High pressure destroys cartridges and seals no matter how new they are, so replacing the part fixes the symptom and the drip returns. Hard water scale is the other common cause. We measure static pressure with a gauge on every fixture call, which is how you avoid paying for the same repair twice.
Plumbing code caps static pressure inside a home at 80 psi. Denver sits on rolling terrain and elevation differences across the distribution system mean many homes, particularly in lower lying neighborhoods, run higher than that. Above the limit you get failing cartridges, weeping toilet fill valves, shortened life on every seal in the house, and voided fixture warranties. The correct fix is a pressure reducing valve at the service entrance.
Yes. Plenty of homeowners choose their own fixtures and we install customer supplied products regularly. We will tell you before we start if the fixture will not fit your rough in, your countertop hole spacing, or your drain configuration, so you have time to exchange it rather than discovering the problem with the water shut off.
A disposal is a motor load. It needs a properly sized circuit so it is not tripping a breaker shared with other kitchen appliances, and a switch positioned where you can reach it quickly. We regularly find disposals wired into shared circuits, which is why they cut out when the microwave runs. Because we hold an electrical contractor license as well as a plumbing registration, we can correct that on the same visit.
Current code requires GFCI protection for kitchen receptacles serving these appliances in a dwelling. Many older Denver kitchens do not have it. When we replace a disposal or hook up a dishwasher we check what is actually there, and we can bring the receptacle up to current requirements under our own electrical license rather than sending you to another contractor.
Supply line failures are among the most common causes of residential water damage, and the usual failure point is a plastic compression nut that has become brittle with age. We recommend braided stainless lines with metal nuts, and we replace supply lines as part of any fixture work rather than reconnecting a line that is already ten years old. The cost difference is small and the downside of a failure is not.
Usually yes. A straightforward toilet replacement is a same day job, including the flange and wax ring where those need attention. If the flange is broken or the subfloor around it has water damage, that adds scope, and we will show you what we found before doing the extra work.
Yes. We handle fixture rough in and set for remodels, including moving supply and drain locations where the layout is changing. Remodel work is scheduled rather than dispatched, so call with your timeline and drawings if you have them.
Straightforward like for like fixture replacement generally does not require a permit. Work that moves or adds supply and drain piping, or that involves new electrical circuits, typically does. We pull what the job requires and meet the inspector, and we will tell you up front which category your project falls into.
Where We Work

Fixture Service Across Denver Metro

Dispatched from our Centennial office at 7076 S Alton Way, Suite H-200.

Fixtures are one part of our full range of Denver plumbing services. See also water heater repair and installation.

DenverCentennialAuroraLittletonEnglewoodLakewoodArvadaHighlands RanchParkerCastle RockGreenwood VillageLone TreeCherry Hills VillageWestminster
Book A Fixture Visit

Fixed Once, Not Three Times

A licensed plumber diagnoses the fixture, checks the pressure behind it, looks at the supply lines, and gives you a written price before any work begins. Kitchen or bathroom, repair or replacement, your fixture or ours.

Same day for urgent leaks. Financing options available for qualifying projects, subject to credit approval.

CO Lic. #PC.0005786 · CO Lic. #EC.0101962 · 2M GL · 5M Umbrella · Bonded · Insured
Request Service

Tell Us What Is Leaking

Kitchen, bathroom, repair or replacement
No Cost Consultation
Licensed & Insured
★★★★★
4.9 · 350+ Reviews · BBB A+
⏱ Takes 30 seconds - we'll reach out to confirm your appointment.
Service Address (optional - we'll confirm on the call)
Pick a Date